SUPERCAN FB4NW 3D reference model

This preliminary STEP model contains the PCB with holes and all seven connectors: four RJ45, two 2-pin power connectors, and one 10-pin connector. The connectors are separate named components. Other electronic components are not included. Units are millimetres.

The PCB and RJ45 geometry were exported from the EasyEDA project. The RJ45 models have been repositioned to align with the PCB pads. The two power and 10-pin connector models were exported from the EasyEDA component library and aligned to the PCB pads.

This is a preliminary reference. Verify dimensions, mating clearances and enclosure openings against the physical board before finalizing a design. The source models have small geometric interferences, including adjacent RJ45 housings; the 2-pin model has 2.50 mm pin spacing while the PCB pads are 2.54 mm apart. The exported board outline is approximately 48.975 x 72.975 mm; the nominal design outline is 49 x 73 mm. The exported PCB thickness is approximately 1.628 mm including solder mask and is not a measured finished thickness.
